Mr. Hobby MS231 Mr. Mark Softer (40ml)

Mr. Mark Softer is a decal softener. Hard decals can be applied to rough surfaces and curved surfaces.
First, use the brush attached to the cap to apply a small amount to the area where the decal will be applied, and then apply the decal over the applied area. It is possible to apply over the decal that has been pasted in advance, but be careful not to apply too much as the decal will soften rapidly.
Also, since it is water-soluble, rapid softening can be prevented by adding water as appropriate.
After pasting the decal, lightly press the decal with Mr. cotton swab, Mr. clean stick 2 or a dust-free waste cloth so that the decal follows the surface of the part firmly. In that case, wipe off the protruding Mr. Mark Softer to prevent it from becoming too soft.
If air bubbles get in between the decal and the parts (silvering), carefully puncture the decal with a needle or design knife after the decal has dried. After that, by applying Mr. Mark Softer again, the decal will soften again, the bubbles will disappear, and the decal will firmly adhere to the surface of the part.
To prevent silvering, it is a good idea to finish the base with a gloss.